Diy Fishing Pole Holder For Rv

Fishing is a popular pastime that many people enjoy. If you're an RV owner, you know how difficult it can be to store and transport your fishing poles. Fortunately, there's a simple solution: a DIY fishing pole holder for your RV. With just a few supplies and a little bit of elbow grease, you can make a custom fishing pole holder that will make it easy to travel with your gear.

To start, you'll need a few basic supplies. A 1x2 foot piece of plywood, some screws and washers, a drill, a jigsaw, and some sandpaper are all you need to create your pole holder. Begin by measuring and cutting your plywood to the desired size. You may also want to sand down the edges to ensure a smooth finish. Next, use a drill to create four evenly spaced holes in the plywood. These will be used to attach the holder to the wall of your RV.

Once your holes are drilled, you can assemble the holder. Place four washers on each screw and use a power drill to secure the screws into the plywood. Finally, insert a jigsaw into the holes and cut out four slots for the fishing poles. This will allow your poles to rest securely in the holder while you travel. To finish, sand the holder down for a polished look and attach it to the wall of your RV.

With these simple steps, you can easily create a custom DIY fishing pole holder for your RV. Not only will this make it easier to store and transport your fishing gear, but it will also add a unique touch to your vehicle. By following these instructions, you can create a custom holder that will last for years to come and make life much easier for your next fishing trip.

Rear Hitch Fishing Rod Holder Tacoma World